Rehabilitation of Reinforced Concrete Corner Beam-Column Joints Subjected to Damage.

Authors

  • Zana Abdulla Aziz Faculty of Engineering, University of Sulaimani, Kurdistan Region, Iraq. Author
  • Mohamed Raouf Abdulkadir Faculty of Engineering, University of Sulaimani, Kurdistan Region, Iraq. Author

DOI:

https://doi.org/10.17656/jzs.10414

Keywords:

Beam-Column Joints, Damage Strengthening

Abstract

Important structural properties related to strength and deformations of corner beam- column joints damaged and strengthened were studied in this investigation. For this   purpose a total of 18 corner beam-column joints divided into five groups were cast and tested. The cross sections were 150mm X 200mm and 150mm X 250mm for the beam and column, respectively. The legs of each beam and column were 900mm. Group1 specimens were consisted of two control specimens tested to failure. Other groups specimens each consisted of four specimens, two of which were tested up to first crack loading and the other two were tested up to 80% of the expected ultimate load. After preloading, the damaged specimens were strengthened in such a way that Group2 were strengthened with strip of CFRP, Group3 with steel plate strip, Group4 with ferrocement, and Group5 with full CFRP sheets. After strengthening process, the strengthened specimens were retested to failure. The test results indicated that the process of the rehabilitations is successful. After strengthening, the ultimate load was increased by 38.3, 4.25, 6.3, and 42.5 % for Group2, 3, 4, and 5, respectively. The stiffness of the strengthened specimens increased compared to the control specimens. The better strengthening technique was those specimens strengthened with full CFRP sheets. The   effect of cracking due to preloading on the flexural behavior of strengthened beam- column joint was found to be insignificant.

References

AL-Hassani, H. M., AL-Ta'an, S. A., and Mohammed, A. A. “Behavior of damaged reinforced concrete beams

strengthened with externally bonded steel plate”; Tikrit Journal of Engineering Sciences; Vol.20, No.2, 2013, pp.48-59. DOI: https://doi.org/10.25130/tjes.20.2.05

Abdul-Muttalib, AL-Mussaue, I. S., Amjad, and AL-Modhafer, H. A. “ Behavior of concrete beams reinforced in

shear with carbon fiber reinforced polymer”; Journal of Engineering; Vol.17, No.1, 2011, pp.46-61.

Ajeel, A. E., Ghedan, R. H., and Hamza, D. M., “Replacing of internal tension bars by external bonded plate”;

Journal of Engineering and Development; Vol.15, No.3, 2011, pp.90-103.

Khan, S.U., Rafeeqi, S. F. A., and Ayub, T.“ Strengthening of RC beams in flexure using Ferrocement”;

International Journal of Engineering Science and Technology; Vol. 37, No. C+, 2013, pp. 353-365.

AL-musallam, T.H., AL-sayed, S.H., AL-Salloum, Y.A., and Siddiqui, N.A., ”Seismic response of FRP-

strengthened corner RC beam-column joints”; Concrete Repair, Rehabilitation and Retrofitting II, 2009, pp.1157-1162.

Ramakrishna, R.V.S., and Ravindra, V.,”Experimental investigation on rehabilitation of reinforced cement concrete

interior beam-column joints using CFRP and GFRP sheets”; International journal of engineering science and

technology; Vol. 4, No.03, 2012, pp.874-881.

Published

2015-04-19

How to Cite

Rehabilitation of Reinforced Concrete Corner Beam-Column Joints Subjected to Damage. (2015). Journal of Zankoy Sulaimani - Part A, 17(3), 205-214. https://doi.org/10.17656/jzs.10414